Worksite Hazards Assessment
Employers must ensure that work areas are inspected for hazards, and they must correct or eliminate the hazards before operation of an aerial lift occurs. They must conduct a walk-around inspection of the job site to identify and address hazards such as:
- Drop-offs, holes, or unstable surfaces, such as loose dirt
- Inadequate ceiling heights
- Slopes, ditches, or bumps
- Debris and floor obstructions
- Overhead electric power lines and communication cables
- Other overhead obstructions
- Other hazardous locations and atmospheres
- High winds and other severe weather conditions, such as ice
- The presence of people in close proximity to the work
When working outdoors weather is an important factor to consider. Not all lifts are made for outdoor use. In the absence of the manufacturer's specific written advice, seriously consider postponing use of the lift if the wind speed/gust is in the range of 15-28 mph. If the wind speed is above 28 mph use of the lift must be canceled. Always check the weather for conditions like rain, snow, sleet, hail, ice and wind, and ensure the lift you are using is suitable for those conditions.
Fall Protection
Fall Protection for Aerial Lifts
- Verify that all required fall protection equipment is present and in good condition. Employees working on aerial lifts must wear a fall arrest or travel restraint system and attach it to the boom or basket of the aerial lift.
- Ensure workers are trained in the proper use of fall protection equipment and know how to respond in the event of a fall or equipment failure.
Knowledge Check Choose the best answer for the question.
3-5. Which choice indicates a proper worksite hazard assessment has been completed before using an aerial lift?
You forgot to answer the question!